HO EMD SW7 - DCC & Sound - Conrail #8896

From coach and freight yards to primary power for shortlines, the WalthersMainline SW7 is a perfect choice for your HO layout! Delivering 1200-horsepower from an updated 567A prime mover, the prototypes proved popular with both railroads and industrial lines, with nearly 500 produced in just two years. Based on Phase II production units constructed from 1950 to 1951 with several still in service, each layout-ready model is packed with features including:

- One time run of these roadnumbers, order now - limited quantity available
- Used by dozens of railroads and industrial lines for switching, local and branch line service with several preserved today!

Based on Phase 2 prototypes built from 1950 to 1951 with:
- Wire grille radiator cover
- Dual tall conical exhaust stacks
- Large front radiator grille
- Single straight hood to cab transition
- 6 louvered side doors with letterboard gap
- Small square center cab windows
- Factory-installed grab irons on hood and cab
- With or without footboards as appropriate
- 4 styles of headlights to match prototype practice as appropriate:
- Original large single
- Retrofit horizontal dual
- Retrofit dual vertical
- Dual sealed beam

Available with ESU(R) Sound and DCC for DCC and DC layouts featuring:
- Fully DCC compatible
- 14, 28, 128 speed steps
- Dual mode DC and DCC
- 4 air horns changeable by CVs
- 2 bells changeable by CVs
- Full 8-notch 567A prime mover sounds
- Compressor

Same powerful drive as WalthersProto(R) locos featuring:
- Five-pole skew-wound motor
- 14:1 gear ratio
- Helical-cut gears for quiet operation and easy multiple unit operation
- All-wheel drive and electrical pickup
- Dual machined brass flywheels
- Heavy die cast metal chassis
- Constant and directional LED headlights
- Next18 DCC Plug
- RP-25 metal wheels

PLEASE NOTE: When operating Walthers-branded DCC-equipped locomotives in DC mode, do not use power packs that exceed an 18V rating. This includes MRC 1300-series power packs which have known issues with our decoders.

Alternate horns and bell sounds can be programmed on the sound decoder using these CVs:
Horns: CV163 = Leslie A-200
CV163 = Wabco Single Chime
CV163 = Nathan M3
CV163 = Leslie S3L

Bells: CV164 = Bronze Bell (default)
CV164 = Steel Bell